tonlist 发表于 2005-9-15 14:08

看来我必须把主扳得手册找出来才可能知道那两个灯代表什么。
有些人特意在主板上装了各种颜色的灯。。。
问题是老机子,不知道还有没有主板手册,想在网上搜一个,有个网站提供email寄得,再看看。。。

[ 本帖最后由 tonlist 于 2005-9-15 15:32 编辑 ]

gaga 发表于 2005-9-15 14:31

如果有主板说明书的话仔细翻翻,应该在上面有说明。
没有的话去下载说明书,主板厂商网站上应该有。
这样的老板子即使烧了也不用太心疼,ebay上大概10欧就能买到

tonlist 发表于 2005-9-15 15:04

找到了:
1. The DIMM Standby Power LED will light when the system is in the power-on or Suspend mode. It will not light when the system is in the Soft-Off state.
2. The PCI Standby Power LED will light when the system is in the power-on, Soft-Off or Suspend mode.
3. 3.3VSB Standby for PCI (jumper J18) - The default setting of jumper J18 is On. It provides 3.3VSB Standby
power to the PCI slots. If you are using a PCI modem card that does not comply to the PCI 2.2 specification, please set this jumper to Off. The PCI Standby Power LED’s light will subsequently turn off.
4. Lighted LEDs serve as a reminder that you must power-off the system then turn off the power supply’s switch or unplug the power cord prior to installing any DIM modules or add-on cards.

哈哈第四条,第一次开机一切正常也读到95MB,因为灯亮着以为没插好,没有断掉电源的情况下,把RAM松了又插,结果开机后只有32MB而且系统好不稳,显像不完整。。。原来问题出在这!

太高兴了,竟然还懂得看主板手册,过去不知道这手册还有用途!

嗯,以后跟高手多多学习!!!!谢谢!

tonlist 发表于 2005-9-15 15:23

鼓起勇气问一下gaga,你为什么特别钟情于现在的头像?

我总觉得像丐帮帮主,他是你的偶像吗?

建议换帅一点的可以吗?

以后有问题,别不理我,怕怕!!!

gaga 发表于 2005-9-15 21:49

原帖由 tonlist 于 2005-9-15 16:23 发表
鼓起勇气问一下gaga,你为什么特别钟情于现在的头像?

我总觉得像丐帮帮主,他是你的偶像吗?

建议换帅一点的可以吗?


:mad: :mad:

daniellwolfe 发表于 2005-9-16 00:31

原帖由 tonlist 于 2005-9-15 16:23 发表
鼓起勇气问一下gaga,你为什么特别钟情于现在的头像?

我总觉得像丐帮帮主,他是你的偶像吗?

建议换帅一点的可以吗?

以后有问题,别不理我,怕怕!!!
人家要的就是个性。。
人说。没有个性,人类的伟大就不存在了。。。哈哈。。。快跑$怕怕$

p.s.我家还一堆电脑零件呢。。昏死了都要。。
页: 1 2 [3]
查看完整版本: 请问自行加一块内存该注意什么